A low phase noise microwave frequency synthesizer based on parameters optimized NLTL for Cs fountain clock

Abstract: We report on the development and phase noise performance of a 9.1926 GHz microwave frequency synthesizer to be used as the local oscillator for a Cs fountain clock. It is based on frequency multiplication and synthesis from an ultralow phase noise 5 MHz Oven Controlled Crystal Oscillator (OCXO) and 100 MHz Voltage Controlled Crystal Oscillator (VCXO).The key component of the frequency multiplication is a non-linear transmission-line (NLTL) used as a frequency comb generator. The phase noise of the synthesizer is improved by carefully optimizing the input power, the input and output impedances of the NLTL. The absolute phase noises of the 9.1926 GHz output signal are measured to be -64 dBc/Hz, -83 dBc/Hz, -92 dBc/Hz, -117 dBc/Hz and -119 dBc/Hz at 1 Hz, 10Hz, 100Hz, 1 kHz and 10 kHz offset frequencies, respectively. The residual phase noise of the synthesizer is measured to be -82 dBc/Hz at 1 Hz offset frequency. The measurement result shows that the absolute phase noise at the frequency range of 1 - 100 Hz is mainly limited by the phase noise of the OCXO. The contribution of the absolute phase noise to the fountain clock short-term frequency stability is calculated to be 7.0x10^-14. The residual frequency stability of the synthesizer is measured to be1.5x10^-14, which is consistent with the calculated frequency stability due to the residual phase noise of the synthesizer. Meanwhile we designed and realized an interferometric microwave switch in the synthesizer to eliminate the frequency shifts induced by the microwave leakage. The extinction ratio of the switch is measured to be more than 50 dB. In the scheme, we use only commercially available components to build the microwave frequency synthesizer with excellent phase noise performance for high-performance Cs fountain clocks.